Alesis Plus - Playing Back a Sample

11
11
PLAYING BACK A SAMPLE
There are three ways to play back a recorded sample: from the front panel, from
an audio trigger, or through MIDI. Playback from the front panel (manual
playback) would normally be used when you want to manually trigger a recorded
sample. Playback from an audio trigger is normally used when replacing one
audio source with a recorded sample, as in the case of replacing a snare drum
on a tape track with a better recorded sample. Playback through MIDI enables a
recorded sample to be played from a MIDI keyboard.
PLAYBACK FROM THE FRONT PANEL
1) Press the DELAY button. The display will read:
SAMPLE PLAYBACK:
ONE SHOT
One Shot means that once a sample is initiated, it will play until the end of
the sample and then stop.
2) To begin playback, press the
EQ button. The sample will play to the end and
then automatically stop. To playback again, press the
EQ button again.
3) The volume of the sample can be increased or decreased by the
OUTPUT
control of the QuadraVerb Plus.
1A) If you wish to have the sample play back continuously until told to stop,
press the "Down"
VALUE button. The display will read:
SAMPLE PLAYBACK:
LOOPING
2A) To begin playback, press the EQ button. The display will then read:
PUSH EQ TO STOP
SAMPLE PLAYBACK
3A) To stop playback, press the EQ button again. The display will then read:
PUSH EQ TO TRIG.
SAMPLE PLAYBACK