Alesis Plus - Adjusting the Sample Mix Parameters

15
15
This page will determine at what point in the sample that playback will
start.
3) Press the
VALUE button to select the desired Start time.
The start can be anywhere in the sample in 10 millisecond steps. When the
start of the sample is moved, the length of a loop is maintained unless the
end of the sample is reached before the loop duration. In this case, the loop
duration will be from the start to the actual end of the sample regardless of
the loop duration. However, the duration value will remain intact and in effect
as soon as the user adjustment of the loop start will permit the proper length.
The range is from 0 through 1.5 seconds in 10 millisecond increments.
4) Press the
PAGE "Up" button. The display will read:
SAMPLE LENGTH:
1.55 SECONDS
This page will determine the length of the sample playback.
5) Press the
VALUE button to select the desired Sample length time.
ADJUSTING THE SAMPLE MIX PARAMETERS
The MIX section allow for adjusting the relative balance between the direct
signal, and the recorded sample playback signal.
1) Press the
MIX button. The display will read:
DIRECT SIGNAL
LEVEL: + 50
This page controls the level of the direct signal.
2) Press the
VALUE buttons to select the desired direct signal level. The range
is 0 to 99 with 0 being off.
3) Press the "Up"
PAGE button to select the next page. The display will read:
SAMPLE PLAYBACK
SIGNAL LEVEL: + 50
This page controls the output level of the recorded sample.