7
6) Pressing the "Up" PAGE button again will select the individual Tap output
volume to be edited, which will read:
TAP 1 VOLUME:
50
Pressing the VALUE buttons will select the desired Output Volume. The
range is 0 to 99.
7) Pressing the "Up"
PAGE button again will select the individual Tap Panning to
be edited, which will read:
TAP 1 PANNING:
LEFT<-00->RIGHT
Pressing the VALUE buttons will select the desired Panning from Left to
Right. The range is Left 99 to Right 99.
8) Pressing the "Up"
PAGE button again will select the individual Tap Feed-back
to be edited, which will read:
TAP 1 FEEDBACK:
00%
Pressing the VALUE buttons will select the desired amount of feedback.
The higher the feedback value is set, the more repeats will occur. The
range is 0 to 99.
9) Pressing the "Up"
PAGE button again will select the Master Feedback to be
edited, which will read:
MASTER FEEDBACK:
00%
Pressing the VALUE buttons will select the desired amount of feedback.
This is a global parameter, scaling the feedback of all taps at once. The
range is 0 to 99.
To Next Page
Loading...