6
DELAY INPUT 1:
POST EQ
Pressing the VALUE buttons will select the other input choice which will
read:
DELAY INPUT 1:
PRE EQ
This page selects whether the input signal to Input #1 of the Delay section
is derived either before (Pre) or after (Post) the EQ. This page is also
identical to the original QuadraVerb configuration.
3) Pressing the "Up"
PAGE button again will select the next page which will read:
DELAY INPUT MIX:
1<-00 -> PITCH
Pressing the VALUE buttons will select the mix between Delay Input #1
(which was selected on the previous page) or the second Delay input
which is dedicated to the output of the Pitch section. This page is also
identical to the original QuadraVerb configuration.
4) Pressing the "Up"
PAGE button again will select the Delay Tap to be edited,
which will read:
TAP NUMBER:
1
Pressing the VALUE buttons will select the desired Tap. The range is 1 to
8.
5) Pressing the "Up"
PAGE button again will select the Tap Delay Time page,
which will read:
TAP 1 DELAY TIME:
0125 millisecs
Pressing the VALUE buttons will select the desired Delay Time measured
in milliseconds. The tap number selected on the previous page is
displayed on the first line. If the cumulative delay time of the 8 taps
exceed 1500 milliseconds (1.5 seconds), the delay time will not be
allowed to increase.
To Next Page
Loading...