22
Controls
The vehicle lift system is designed to
raise the ground clearance of the
vehicle and increase the vehicle's
approach and departure angles, when
approaching severe changes in
gradient.
The system is activated by the
instrument panel mounted switch.
When the system is activated, the
vehicle speed must not exceed 10
kph. If the switch is pressed with the
vehicle exceeding this speed the
system will not activate until a drop in
speed, to 10 kph, is achieved.
When returning the vehicle to its
normal ride height, press the switch on
the instrument panel and the vehicle
will start to lower. It is important that
the vehicle is allowed to lower to its
normal ride height before driving is
continued.
The parking brake (handbrake) is
applied by pulling back the lever until it
locks into position. To release the
parking brake, the sleeve on the lever
must first be lifted, then push the lever
fully forward.
The vehicle is fitted with an air
adjustable steering column. The
column is adjustable for height and
rake.
The foot operated column adjustment
switch is mounted in the floorplate near
the column.
To adjust the column position, the
handbrake must be applied. Grasp the
steering wheel and depress the foot
button, move the steering wheel to a
comfortable driving position and
release the foot button to lock the
column in position.
WARNING
It is essential to apply the
parking brake when leaving
the vehicle.
Ferry Lift Parking Brake Steering Column
To Next Page
Loading...