15
Turning on the boiler , turning off the boiler by pressing the key for more
than 3 seconds after the acoustic signal.
If the system blocked, you can unblock it by pressing this key for more
than 3 seconds after the acoustic signal.
Changing values and settings in menus and submenus
Navigating menus and submenus
Navigating (changing) menus and submenus
Access to the visualization menu
Leaving the current menu or submenu
Entering the menu or submenu
Enables changes in the menu
Keeps (records) data in the menu
Reset system maintenance 2
Function
The timer is reset (only if this option is activated)
By pressing the button for more than 3 seconds, the system goes into
the Standby mode.
Led symbols:
Led light is on: The lighter is on
Led light is on: Auger is operating
Led light is on: Pump is operating
Led light is on: Aux 1 outlet has been activated
Led light is on: Additional motor has been activated
Led light is on: Aux 2 outlet has been activated
Led light is on: Aux 3 outlet has been activated
Led light is on: Pellet is missing
Led light is on: Contact is open
Led light is on: Sanitary water is needed
Display:
- Meaning:
Time and date
Chrono modalities (D-Daily, W-Weekly, We-Week-End)
Power system (P1, P2, P3, P4 and P5)
Recipe (Pellet 1)
System states (Check Up, Ignition, Stabilization, Run Mode, Modulation, Standby, Safety, Extinguishing, Recover
Ignition, Block, Off)
-Errors (Alarms):
When an error occurs (alarm), the system enters the Block Phase (Block)
Safety thermostat activated
Safety pressure switch activated
Turning off due to too low temperature of flue gases
Turning off due to too high temperature of water in the boiler
Turning off due to too high temperature of flue gases
Safety thermostat activated on the auger housing
An encoder error. A signal is missing
To Next Page
Loading...