OVERVIEW
Each UV system is designed to treat water at specified flow rates as outlined in the specification
sheet. All EcoStream units are provided with two main component parts, specifically the
ultraviolet reactor chamber and the main controller.
Reactor Chamber
The reactor chamber is manufactured from stainless steel 316L and houses the ultraviolet lamp
and quartz sleeve. All EcoStream UV systems use only a single UV lamp. The lamps used in the
Alfaa EcoStream Models ECS60R – ECS310R are of a special high intensity, high output and
Amalgam germicidal type. The chamber is designed to mount both horizontally or vertically and
should be secured to a suitable support.
Control Panel
The main controller is made of aluminum or GI depending on model. The controller is
connected to the chamber via 2 meters of cable to allow for application flexibility. The panel
can be mounted either horizontally or vertically on the wall.
Standard Electronics
1. All EcoStream control boxes are equipped with a soft start on/off switch. When the main
power to the system is turned on, the lamp will turn on directly. However, if required, the
lamp can be turned off (and subsequently on) by using holding down the “power” button on
the EcoStream Control box for 2 seconds.
2. A separate user accessible fuse is also provided as protection for the electronics.
3. A seven segment LED display monitors the remaining number of useful hours of the UV
lamp (Time Elapse Meter) and the days the UV system has been in operation.
4. An audio-visual “Lamp Life Over” and “Lamp Failure” indicator.
5. The Ecostream+ models include a built in UV Intensity meter along with sensor.
To Next Page
Loading...