4
The fastest lap, followed by all other laps with respective times and corresponding additional information.
Split time (In RECALL mode only) :
On tracks with 2 or 3 magnetic strips « line A » also shows the time between each magnetic strip. (See Chapter 4°, Sub-Menu
-1- )
B RPM COUNTER
In the START mode :
The system user has two RPM display options : « M » ou « D »
M = MAXIMUM, the highest engine RPM of the last lap This data remains on the display during the next lap.
D = DIRECT, direct display of engine RPM
In the RECALL mode :
The highest recorded RPM for each lap is displayed .
C BEST TIME DISPLAY
The arrow appears in front of the fastest time and remains visible as long as the information is shown.
D HIGHEST RPM DISPLAY
The arrow appears in front of the highest engine RPM and remains visible as long as the information is shown.
E ENGINE TEMPERATURE
In the START or STOP mode :
The directly recorded thermometer temperature is shown every 0.8 seconds on the display for a safe reading. The temperature
shown :
From « +0°F à +150°C ou de +32°F à 302°F » for the water temperature
From « +46°F à +299°C ou de +115°F à 570°F » for the CHT
Below or above those temperatures ranges the system shows LO or HI
In the RECALL mode :
The maximum recorded temperature for each lap.
F ENGINE TEMPERATURE ALARM
If the engine temperature exceeds the programmed temperature a large black circle appears.
G ENGINE RUNNING TIME COUNTER (MOTOR)
The running time of the engine is shown in this line in hours and minutes. Select the desired counter and reset one of the
system's 5 counters for the engine running time to zero. The number of the counter is shown under « LINE H ». The selected
engine running time counter is continuously updated whether the system is in the START or STOP mode.
REMEMBER :
The RPM wire should be connected
(see Chapter 1° “Installing the RPM sensor”)
H ENGINE NUMBER (MOTOR)
This display is helpful if a number of engines are used in the vehicle. If the engine is exchanged another counter should be
selected (5 counters are available in the ALFANO).
I TOTAL TIME (TIME)
Total measured time in hours and minutes.
J NUMBER OF SESSIONS (ETAP)
This display indicates the number of session. Whenever the system switches from STOP to START mode, the counter displays
an additional session.
To Next Page
Loading...
Need help?
General
