P.16
POWER SUPPLY
Please use the attached power, note that power voltage and frequency are the same as the marked voltage and
frequency of device when connecting power. Every device's power should be connected separately, so that de-
vice can be controlled individually.
CABLE SPEC.
DMX CONNECTION
Connection between laser lights and DMX must use the shied cable of diameter more than 0.5mm. Please use
the attached 3 pin XL plug/socket to connect the DMX output/input interface. The connection between socket
and cable as below (note the plug/socket's 3 pin number and position).
When using standard DMX512 control signal, the last device's output interface must be connected to a DMX plug.
This plug is putting a 120 ohm resistance between "canon" plug's 2 pin and 3 pin. Showing as below pic. Sticking
this plug into the last device's signal output interface, it will avoid the interference during the process of signal
transmission.
Attention! The installation must be carried out by qualied service personal only. Improper installation can re-
sult in serious injuries and /or damage to property. Overhead rigging required extensive experience! Working
load limits should be respected, Certied installation materials should be used, the installed device should be
inspected regularly for safety.
PRODUCT INSTALLATION
RIGGING
1
2
3
1
2
3
DMX-OUTPUT
XLR mounting-sockets (rear view) XLR mounting-plugs (rear view)
DMX-INTPUT
1 ∙ Shield
2 ∙ Shield (-)
3 ∙ Shield (+)
PIN3
PIN2
CABLE (EU) CABLE (US) PIN INTERNATIONAL
Brown Black Live L
Light Blue White Neutral N
Yellow/Green Yellow/Green Earth
FUSE : 5x20mm
250V~ 3.15A slow
LEN
ClampSafety rope
Before rigging make
sure that installation
area can hold the 10
times weight of device.
To Next Page
Loading...