18
9 • ROUTINE MAINTENANCE
9.3 • PLACEMENT INTO SERVICE
AFTER A LONG PERIOD OF NON-USE
After a long period of non-use, it is
advisable to contact your trusted help
service to arrange a visit in order to check
whether any maintenance is required.
If you wish to act independently, proceed
as follows, remembering that the
manufacturer recommends the annual
inspection of the appliance.
a) Flush the water tubes to prevent any
deposits or residue from clogging the
solenoid valves and then reconnect the
supply tubes.
b) If a Brita filter is installed, check the
date of installation (the filter must be
replaced within a year, otherwise the active
carbons will deteriorate and cause the
potential spread of bacteria), flush the filter
and if necessary replace it according to the
instructions in the user manual.
c) Check the connection/reconnect the
drain tube.
d) Connect the electrical power supply
and energize the appliance (taking care
not to invert the phases and neutral for
gas appliances in order to avoid error
messages)
e) Open the gas supply system valve.
f) Turn the appliance on by pressing the
power-on knob for 3 seconds
g) Insert/connect the cans of chemical
product
h) Check that there are no leaks from the
water and gas connections
i) If a message appears, take note or
photograph the display and get in contact
with your trusted help service
j) Check whether a software update is
available; this is available for download
from the manufacturer’s portal.
k) Run a cleaning programme to prime the
cleaning system pumps and check for any
water leaks.
10 • SPECIAL MAINTENANCE
As explained in the Installation manual
and Warranty...
10.1 • For correct and safe operation, the oven
must be subjected to special maintenance
at least once per year by the technical help
service.
10.2 • It is advisable to sign a maintenance
contract with the technical help service to
ensure this operation is regularly carried
out.
For the softener, follow the supplier’s
instructions.
90036450rev01
To Next Page
Loading...