ALI M - Routine Maintenance

16
9 • ROUTINE MAINTENANCE
9.1 • DAILY CARE
Daily care of the appliance will allow the
extension of its service life and reduced
maintenance costs.
COOL THE MACHINE AND WEAR PPE
GASKET
During periods of non-use and during
the night, leave the door slightly ajar, not
closed.
Perform the automatic cooling function
with the door open before shutdown at the
end of service.
Regularly remove the gaskets and any
deposits accumulated on the inner door
glass during cooking.
Use only microfibre cloths and neutral
cleaners to clean the gaskets, glass and
inner and outer surfaces.
Do not use abrasive and aggressive
chemical products.
DOOR GLASS
Regularly clean the inner door glass of any
cooking residue using a soft rag.
Regularly open the inner glass by freeing
the clips and proceed to clean both glass
panes.
Never use abrasive products so as not
to damage the glass surface, which may
shatter during cooking.
GREASE FILTER
Remove the grease filter before daily
cleaning at the end of service, and wash it
separately.
GREASE DRIP PAN
Remove the drip pan before each cleaning
cycle and wash it separately to stop the
residue from clogging the grease drain.
CORE PROBE
Remove the probe from the product only
by gripping the probe handle; do not pull
on the probe cable.
Regularly remove any cooking residue from
the core probe cable.
If the probe cable is twisted, handle it
carefully, making sure not to pull it.
Do not exert too much force when
inserting the probe in frozen products
• PERIODICALLY ...
... it is advisable to clean the deflector and
the pan holder racks, as required.
To do this, perform the following actions:
• stop and shut off all supplies (electricity,
water and if present, gas);
• remove the pan holder rails;
• loosen the deflector screws with a
suitably-sized screwdriver or a coin, so
the rear part can be cleaned. For a more
thorough cleaning, use the shower head
(optional);
• if there are carbon deposits, remove them
and increase the cleaning level/frequency;
• dry with a clean cloth;
• the deflector must be removed if the
dirt is difficult to remove. Do not use
abrasive pads or scouring sponges
which could damage the steel surface. If
the dishwasher is big enough, wash the
deflector in it.
Fasten the deflector inside the oven,
ensuring that the two fastening screws on
the right-hand side are tightened properly.
90036450rev01