ALIBI ALI-NS3014R User Manual (English)

To Next Page

www.observint.com

ALI-NS3014R_CQ

10/13/15

Step 1. Install the camera

1. Determine the best fasteners for securing the camera to mounting surface. The mounting hardware

provided is suitable for most surfaces.

2. Using the Drill Template provided, mark the location of the mounting screw holes. If the drop cable

will be routed through the mounting surface, mark the location of the hole for the cable. NOTE: The

drop cable can be routed through the cable channel on the side of the base.

3. Drill holes for the mounting fasteners, and for the drop cable if needed.

4. Route the drop cable as planned, then secure the mounting base to the surface with the fasteners.

5. Wire the ground terminal on the back of the camera to an earth grounded conductor.

Step 2. Connect the camera to the LAN and power it on

1. Route a Ethernet LAN cable to the camera and plug it into the Ethernet connector. Seal the

connection from moisture and other contamination. A weatherproof tting is provided.

Ethernet connector

Drop cable

12 Vdc Power

connector

If the camera is powered through the LAN cable (PoE), apply power to the cable to power on the

camera, then continue to “Step 3. Install the Alibi Discovery Tool” on page 4

2. Route a 12 Vdc power cable to the camera and connect it to the 12 Vdc connector on the camera

drop cable. The polarity of the drop cable connector is shown below.

CAUTION



Before applying power to the camera, ensure that the polarity is correct. An incorrect connection

may cause a malfunction and can damage the camera.

Seal the power cable connectors as needed from moisture and other contamination.

Apply power to the cable to power on the camera.

Step 3. Install the Alibi Discovery Tool

Alibi Discovery Tool is a software utility used to “discover” Alibi cameras and NVRs/DVRs installed on the

physical Ethernet network (LAN) and change their network settings. Discovery Tool is provided on the CD

with your camera and is contained in Alibi Power Tools. To use Discovery Tool:

1. Insert the software CD provided with your camera into an optical drive on the Microsoft Windows

computer you will use to access your camera on the LAN.

2. On the CD, nd the folder that contains the Alibi Power Tools (Alibi Tools Utility).

3. Install Alibi Power Tools. Refer to the ALIBI™ Power Tools Installation and User Manual also provided

on the CD. When the program opens, the following screen appears.

ALI-NS3014R 4.0 MP IP Bullet

Camera Quick Installation Guide

This document guides you through the basic steps to install and congure the ALI-NS3014R camera. For

more information about the features of these cameras, please refer to the ALIBI IP Camera Software V2

User Manual.

Features

• 4 Megapixel CMOS progressive scan sensor

• High denition video streaming up to 2688 x 1520 pixels with Dual-stream video support

• Video stream compression using H.264 standard

• 3D-DNR noise reduction and Wide Dynamic Range (WDR)

• Backlight compensation

• IR sensors for night vision

• Dual power capable - Power over Ethernet (PoE) or 12 Vdc

• Weatherproof - IP66 rated

Sun shield adjustment screw

Sun shield

IR array

Lens

Ground terminal

Reset button

(recessed)*

Cable channel

Drop cable

Adjustable bracket

lock nut

Adjustable bracket

Mounting base

* To reset the camera to its factory state, press and hold the reset button for 10 seconds during reboot or power on.

What’s in the box

The box contains this document with the items shown below.

Drill Template Documentation and

Installation Tool CD

Weatherproof tting

for Ethernet cable

ounting screws

and wall inserts

Need help?

Do you have a question about the ALIBI ALI-NS3014R and is the answer not in the manual?

ALIBI ALI-NS3014R Specifications

General

Model	ALI-NS3014R
Image Sensor	1/2.8" Progressive Scan CMOS
Sensor Type	CMOS
Lens Mount	M12
Wide Dynamic Range	Digital WDR
Digital WDR	Yes
Weatherproof Rating	IP67
Weather Resistance	Yes
Ingress Protection	IP67
Category	Security Camera
Day/Night	Auto switch (ICR), Color/BW
Video Compression	H.265/H.264
Frame Rate	Main Stream: 30fps (2304 × 1296, 1920 × 1080, 1280 × 720)
Network Interface	10/100Mbps Ethernet (RJ45)
Protocols	TCP/IP, HTTP, HTTPS, FTP, DHCP, DNS, DDNS, RTP, RTSP, RTCP, NTP, UPnP, SMTP, IGMP, ICMP, 802.1x, QoS, IPv6, Bonjour
Power Supply	12V DC ±10%, PoE (802.3af)
Power Consumption	12V DC: 5W max; PoE: 6.5W max
Operating Temperature	-22°F to +140°F (-30°C to +60°C)
Operating Conditions	Humidity 90% or less (non-condensing)
IR Distance	Up to 30m
Night Vision	Yes
On-board Storage	No