4 www.Observint.com
© 2015 Observint Technologies. All rights reserved.
After conguring the date and time, click Next to start the clock at the time entered.
6. In the Network setup Wizard window, click the eld value you want to change, then use the pop-up aid to enter a new value. By
default, the NVR uses DHCP (Dynamic Host Conguration Processor) to acquire compatible (dynamic, changeable) network settings
from a network DHCP server. Generally, it is preferable to setup the NVR with a xed network settings to assure the NVR has an
unchanging IP address, which is convenient for remote login.
a. To enable xed network settings, rst, un-check the Enable DHCP box. If a DHCP server is active on your network, the IPv4
Address, IPv4 Subnet Mask, IPv4 Default Gateway elds will be populated with network settings assigned by the server. These
settings are compatible with your network. If the elds are not populated, they will be blank as shown above.
b. Enter (or modify, if necessary) the IPv4 Address, IPv4 Subnet Mask, IPv4 Default Gateway elds to settings compatible with
your network using the virtual keyboard. You can also enter a Preferred DNS Server address (optional, ex. 8.8.8.8 {Google]).
Consult with your network administrator to determine the best network settings for your NVR.
7. Click Next after you congured the network parameters to open the a window for conguring the network ports you prefer to use.
You can also congure your recorder for DNS (Domain Name Server) access at this time. For more information about these settings,
please refer to the ALIBI Embedded Network Video Recorder Firmware V3.3.4 User Manual available for download from your
vendor. If unsure about how to setup ports and DNS access, click Next to continue.
b. In the screen shown below, enter a new admin password in the New Password eld. A valid password must contain
8 - 16 characters and including characters from at least two of the following groups: numbers, lowercase (a .. z), uppercase
(A .. Z), special characters. A strength rating of your new password will appear on the graph on the right.
c. Enter the same password in the Conrm eld, and then click OK to continue.
4. In the next window, click OK to use the Wizard to perform the initial conguration of your recorder.
5. In the next screen, set the time zone and date format (using the drop down menus), and the date and clock in your recorder (using the
pop-up graphical menus, see below)). Since video data and capture les are times tamped by the recorder, It is very important that
this information be set precisely to produce valuable evidence from your recorder.
To Next Page
Loading...
