5
www.observint.com
© 2017 Observint Technologies. All rights reserved.
Menu
AGC Support
D/N Mode Auto / Color/ BW (Black and White)
White Balance ATW / MWB
BLC Support
Digital Wide Dynamic Range (DWDR) Support
Language English. Chinese
Functions Brightness, Sharpness, Digital noise reduction, Mirror, Smart IR
General
Operating Conditions -40°F ~ 140°F (-40°C ~ 60°C), Humidity 90% or less (non-condensing)
Power Supply 12 Vdc ±25%
Power Consumption Max. 9 W
Protection Level IP67
Material Metal
IR Range Up to 135 ft (40 m)
Communication Up the coax (HD-TVI output)
Dimensions 5.29” × 4.88” × 4.38” (34.3 mm × 123.9 mm × 110.1 mm)
Weight 1.57 lb (750 g) approx.
Cleaning
Clean the camera dome with an approved glass cleaning solution and a lint free cloth.
• Dust can be removed from the unit by wiping it with a soft damp cloth. To remove stains, gently rub
the surface with a soft cloth moistened with a mild detergent solution, then rinse and dry it with a
soft cloth.
• Remove all foreign particles, such as plastic or rubber materials, attached to the camera housing.
These may cause damage to the surface over time.
CAUTION
Do not use benzene, thinner or other chemical products on the camera assembly; these may
dissolve the paint and promote damage of the surfaces. Before using any chemical product,
carefully follow the accompanying instructions.
Troubleshooting
Problem Possible Cause
Nothing appears on the screen - Check the power connection.
- Check the video signal cable connection to the monitor.
- Check HD-TVI DVR camera settings to verify the video resolution mode of the
camera and HD-TVI DVR match
The video image is dim or not clear. - If the camera lens is dirty, clean it with a soft, clean cloth.
- Adjust the monitor controls, if necessary.
- If the camera is facing a very strong light, change the camera position.
- Adjust the lens focus.
The screen is dark. - Adjust the contrast control of the monitor.
- If you have an intermediate device, set the impedance (75 Ω /Hi-Z)
properly, and check the cable connections.
The camera is not working properly and
the surface of the camera is hot.
- Verify that the camera is correctly connected to an appropriate regulated
power source.
The image on the monitor ickers - Make sure that the camera isn’t facing direct sunlight or uorescent light.
If necessary,change the camera position.
To Previous Page
Loading...
Need help?
General
