Replacing the display back-cover
and antenna assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your computer.
For more safety best practices, see the Regulatory Compliance home
page at
www.dell.com/regulatory_compliance.
Procedure
Place the display back-cover and antenna assembly on a clean and flat
surface.
Post-requisites
1 Replace the display hinges.
2 Replace the camera cable.
3 Replace the display panel.
4 Replace the camera.
5 Replace the display bezel.
6 Replace the display assembly.
7 Follow the procedure from step 2 to step 16 in “Replacing the system board”.
8 Replace the memory modules.
9 Replace the battery.
10 Replace the computer base.
11 Replace the rear-I/O cover.
12 Replace the solid-state drive.
13 Follow the procedure from step 4 to step 6 in "Replacing the hard drive".
14 Replace the wireless card.
15 Replace the base cover.
106
To Next Page
Loading...
Need help?
General
