Removing the Battery Case
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before Working Inside Your Computer. After working inside your computer, follow the instructions in After
Working Inside Your Computer. For more safety best practices, see the Regulatory Compliance home page at dell.com/
regulatory_compliance.
Prerequisites
1. Remove the
stability foot.
2. Remove the right side-panel. See “Removing the Side Panels”.
Procedure
1. Lay the chassis on the right side.
2. Slide and open the battery-compartment door.
3. Remove the batteries from the battery-compartment.
a. battery-case door
b. AA batteries (2)
4. Press the releasing clips on the cable connector to disconnect the battery-case cable from the chassis.
5. Remove the screws that secure the battery compartment to the chassis.
6. Lift the battery-case off the chassis.
23
To Next Page
Loading...
