26 | Setting up the monitor
7. Route the power cable through the cable-management slot on the stand
and then through the cable-management clip at the back of the display.
8. C
onnect the power cable to the monitor.
9. Now route the required cables through the cable-management slot on the
stand and then through the cable-management clip at the back of the
display.
• USB upstream cable
• USB downstream cables (optional, cables are not included)
• HDMI cable
• DisplayPort cable
NOTE: Route each cable neatly so that the cables are organized before
the I/O cover is installed.
CAUTION: Do not plug the power cable into the wall outlet or turn on the
mon
itor until you are instructed to do so.
To Next Page
Loading...
