Using AlienFX function | 73
Adjusting the lighting effects
The LIGHTING panel provides various lighting effects. After selecting the
lighting zone(s) on the preview of the monitor, you can choose an effect from
the LIGHTING EFFECT dropdown list and configure available options.
NOTE: The LIGHTING panel appears only when the supplied USB 3.2
Gen
1 (5 Gbps) upstream cable is connected to your Alienware monitor
and computer.
NOTE: The options displayed may vary depending on the lighting zone(s)
you specified.
Morph
The effect changes the light color into another through a seamless transition.
1. Pick a preferred color from the color palette or the list of PRESET
COLORS. The selected color and its RGB color codes will be displayed on
the right field.
NOTE: To change the color, use the up and down arrow buttons beside
the R/G/B boxes to edit the color codes.
2. To add the selected color to the list of YOUR COLORS for quick access in
the future, click “+”. At most 12 colors can be added to the list.
NOTE: To remove an existing color chip from the list, right-click on it.
3. Repeat the previous steps to specify Color 2 to be the ending light color.
4. Drag the BRIGHTNESS slider to adjust the brightness of the color.
5. Drag the TEMPO slider to adjust the transition speed.
Pulse
The effect makes the light flash with a short pause.
1. Pick a preferred color from the color palette or the list of PRESET
COLORS. The selected color and its RGB color codes will be displayed on
the right field.
NOTE: To change the color, use the up and down arrow buttons beside
the R/G/B boxes to edit the color codes.
2. To add the selected color to the list of YOUR COLORS for quick access in
the future, click “+”. At most 12 colors can be added to the list.
NOTE: To remove an existing color chip from the list, right-click on it.
3. Drag the BRIGHTNESS slider to adjust the brightness of the color.
4. Drag the TEMPO slider to adjust the pulsing speed.
To Next Page
Loading...
Need help?
General
