29
Setting up the monitor
Setting up the monitor
Connecting the stand
CAUTION: The following steps are important to protect your screen. Follow the instructions to complete the installation.
NOTE: The stand assembly is not pre-installed when the monitor is shipped from the factory.
NOTE: The following instructions are applicable only for the stand that was shipped with your monitor. If you are attaching a
stand that you purchased from any other source, follow the setup instructions that are included with the stand.
1. Remove the stand base and stand riser from the packaging cushion.
NOTE: The images are for the purpose of illustration only. The appearance of the package cushion may vary.
Figure 15. Removing the stand parts from the box
2. Align and place the stand riser on the stand base.
3. Open the screw handle at the bottom of the stand base and turn it clockwise to secure the stand assembly.
4. Close the screw handle.
Figure 16. Attaching the stand
To Next Page
Loading...
