T-REX 450SA ARF Contents
4
• 6-channel (or greater) transmitter with helicopter and 120-degree CCPM programming
• 6-channel (or greater) FM, PCM or Spektrum® DSM® (for use with Spektrum transmitters only)
equipped micro receiver
• Three sub-micro servos (with at least 17 oz/in of torque) for swashplate (CCPM) control
• One sub-micro, micro or mini servo (with a .12 sec/60° or faster transit speed) for tail control
• Heading/Tail Lock gyro
• 430-class 3150–3550Kv brushless motor
• 25-amp (or greater) brushless ESC
• 3-cell (11.1V) 2000-2200mAh Li-Po battery pack, capable of 12C (for sport flying only) to 15C
(minimum for 3D flying) or greater discharge rates
• 3-cell Li-Po battery charger
Electronics Required to Complete
Before beginning assembly of your T-REX 450SA ARF, carefully remove the airframe, canopy, windshield,
decal sheet and bags from the box for inspection. Closely inspect the airframe and parts. If you find any
damaged or missing parts, now or during assembly of your model, please contact the place of purchase,
email productsupport@horizonhobby.com, or call 1-877-504-0233 toll free to speak to a product support
representative.
*Actual contents may vary slightly from photos shown
T-REX 450SA Airframe
Decal Sheet Cable/Zip Tie and Canopy Mounting
Grommet Parts Bag
Motor Pinion Gear Parts Bag
Motor Mounting Hardware Parts Bag
Servo Mounting Hardware Parts Bag
Linkage Parts Bag
Spare Hardware Parts Bag
Hex Wrench and Screw Driver Tool Bag
Threadlock and Battery Strap Bag
Canopy and Windshield
To Next Page
Loading...
