Additional Items and Tools Required for Assembly
77
• Adhesive-Backed Hook and Loop Tape (EFL2135)
• Double-Sided Servo Tape (EFL2135)
• Clear tape (Optional)
• Lightweight Oil (TRI4026)
• Isopropyl alcohol
• Hobby Knife (EXL16001)
• Scissors (DYN2511)
• Metric Ruler (MPTH710)
• Metric calipers (Optional)
• Drill and 1/16” drill bit (Optional)
JR 285 Digital Sub-Micro
Servo
(JRPS285: Three Required)
JR 3400G Digital Mini Gyro
Servo
(JRPS3400G)
Align 430L Brushless Motor,
3550Kv
(AGNM4365)
Align 35-Amp Brushless ESC
w/5V BEC
(AGNE35G)
or 6V BEC
(AGNE35X)
Align 2100mAh 3S 11.1V Li-Po Battery Pack
(AGNB21003S)
Recommended Setup for Precision and Aggressive 3D Flying
• #1 Phillips Screwdriver (Optional; EFLA258)
• #0 Phillips Screwdriver (Optional; EFLA257)
• Vise grips (Optional)
• Needle-Nose Pliers (EXL55560)
• Ball Link Pliers (Optional; KSJ673)
• Ball Link Sizing Tool (Optional; JRP960219)
• Soldering Iron (Optional; WELSP40L)
• Solder (Optional; WSD2020)
• Pitch Gauge (AGNH1000)
• Blade Balancer (KSJ1470)
• 1.5, 2.0 and 2.5mm Hardened Tip Hex Wrenches (Optional; DYN2904)
JR G500T Tail Lock Ring Gyro
(JRPG500T)
To Next Page
Loading...
