Owner's Manual
General Precautions (cont'd)
Mechanical (cont'd)
• DO not operate the generator w{th safety guards removed, While the generator is running, do not
attempt to reach around the safety guard for maintenance or any other reason,
• Keep hands, arms, long hair, loose clothing, and jewelry away from moving parts. Be aware that
when engine parts are moving fast they cannot be seen clearly.
Keep access doors on enclosures closed and locked when access _s not required.
When working on or around the generator always wear protective clothing including ANSI
approved safety gloves, safety eye goggles, and safety hat.
Do not alter or adjust any part of the generator that is assembled and supp{ied by the
manufacturer.
Always follow and complete scheduled engine and generator maintenance.
Chemicals
• Avoid contact with hot fuel, oil, exhaust fumes, and hot solid surfaces.
Avoid body contact with fuels, oils, and lubricants used in the generator. If swallowed, seek
medical treatment immediately. Do not induce vomiting if fuel is swallowed. For skin contact,
immediately wash with soap and water. For eye contact, immediately flush eyes with clean water
and seek medical attention.
Noise
Prolonged exposure to noise _evels above 68 DBA is hazardous to hearing. Always wear ANSI
approved ear protection when operating or working around the generator when it is running.
4000W Generator
General Precautions {cont'd)
Extension Cord
If an extension cord (not included) is used, make sure to use only UL approved cords having the
correct gauge and length according to the following table:
Nameplate Amps (@ full load) Cord Lengths
0ft.-50ft. 50ft.-100ft, 100 ft.-150 ft. 150 ft,-200 ft.
0 - 5 16AWG 16AWG 12AWG 12AWG
5.1 - 8 16AWG 14AWG 10AWG
8.1 - 12 14AWG 12AWG
12,1 - 15 12AWG 10AWG
15 - 20 IOAWG IOAWG
Battery
This product does not need a battery.
Owner's Manual
Loose Parts (Wheel kit and handle)
Check all loose parts against the following list. Contact your dealer toll free at 888.896.6881
if any of the loose parts shown are not included with your generator
Hardware Check:
Your Hardware Kit should include:
1) Two Handles with bolts, nuts, pin with chain and brackets
2) One axle shaft with bolts and nuts
3) Two washers
4) Two cotter pins
5) One generator leg with bolts and nuts
6) Two wheels
Assembly
Unpacking
1. Remove the generator and loose parts box from the carton.
2. Compare the accessory with the inventory list below.
L.J
L L-.
--1
L._ 3
6
I
4000W Generator
To Next Page
Loading...
Need help?
General
