2.2 Sockets, LEDs and switches
Triggers an alarm when the housing is opened. To suppress this alarm, it must be
turned off by a parameter setting in the time recording program.
Light up to indicate live network connection
Lights up as soon as the system processes are activated and the device is ready.
Lights up when operating voltage is switched on.
The cold boot switch (1) is used to delete stored data and set default parameters.
The SW switch (2) is used to set the default IP address 172.18.70.52 and temporarily
store the specified IP address.
Is applied over the mortise lock to prevent electrostatic discharges.
Ends active processes and triggers a reboot (restart).
2.3 Touch screen
For optimal use of the touch screen, remove the protective film from the display before using the
device for the first time.
The touch screen has a layer that detects small electrical discharges, such as those emitted by the
human body.
Touch the screen with your fingertip to perform a booking.
The touch screen does not respond when touched with a sharp object such as a stylus.
Make sure that the touch screen does not come into contact with other electrical equipment.
Electrostatic discharges may cause malfunctions.
Make sure that the touch screen does not come into contact with liquids. Moisture or contact with
liquids may cause malfunctions.
To Next Page
Loading...
Need help?
General