Need help?Do you have a question about the ALLEN & HEATH ME U and is the answer not in the manual?
General| Brand | ALLEN & HEATH |
|---|---|
| Model | ME U |
| Category | Music Mixer |
| Language | English |
Details the conditions for warranty claims, including operation and repair by authorized agents.
Read all safety instructions before operating the equipment.
Precautions for positioning, handling, cleaning, and ventilation to prevent damage.
Information on checking and updating the ME-U operating firmware.
Specifies required Cat5 cables for connecting ME-U to ME-1 mixers.
Describes the ME-1 as a stand-alone digital personal mixer for stage monitoring.
Details the ME-U as a touring grade, 10 port PoE hub for personal mixers.
10 ports to distribute audio and power to ME-1 mixers.
Receives audio sources from various mixing systems via input cards.
Resets the ME-U network address to factory default.
Connects to a PC/Mac for system setup and channel naming.
IEC connector for universal voltage power supply (100-240V AC).
Instructions for mounting the ME-U in a 19" rack or on a flat surface.
Procedure to replace the standard ME-D input card with other options.
Connects ME-U output ports to ME-1 mixer Link In ports.
Connects up to 10 ME-1 mixers in parallel via individual Cat5 cables.
Daisy chains ME-1 mixers from any ME-U output port.
Connects multiple ME-U hubs to expand the number of ME-1 mixers.
Specifies shielded twisted pair CAT5e or higher cables with locking EtherCon.
Connects GLD dSNAKE to the ME-D input card for audio and names.
Connects Qu dSNAKE to the ME-D input card for audio and names.
Connects iLive ACE from MixRack Port B using standard ME-D input card.
Uses ACE card option in ME-U to interface with iLive network.
Connects iLive mixer MMO card via Aviom® out to the ME-D.
Connects Aviom® A-Net 16 sources using the ME-D input card.
Interfaces other systems via Dante, MADI, or EtherSound cards.
Steps to power on the ME-U and wait for it to boot.
Configures static TCP/IP addresses for PC/Mac communication.
Accessing the ME-U setup application via a web browser.
Procedure to reset network settings to factory defaults.
Displays current status of hub, input source, and connected ME-1 units.
Configures network settings, source mode, and iDR Mix Rack.
Sets channel names and stereo link status for ME-1 mixers.
Manually enter channel names and stereo linking.
Resets manual names and stereo links to defaults.
Edits received names and stereo status for specific requirements.
Displays firmware version and allows firmware updates.
How to save changes and exit the setup application.
Provides physical dimensions of the ME-U unit.
Lists technical specifications: inputs, outputs, connectivity, and power.
Links to Allen & Heath website for examples, knowledgebase, and firmware.
To Next Page