EasyManua.ls Logo

ALLEN & HEATH Olive S3000

ALLEN & HEATH Olive S3000
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Surface Getting Started Guide
S3000, S5000, S7000
Before starting please check www.allen-heath.com for the latest dLive
firmware and documentation.
AP9899
Question and Answer IconNeed help?

Do you have a question about the ALLEN & HEATH Olive S3000 and is the answer not in the manual?

ALLEN & HEATH Olive S3000 Specifications

General IconGeneral
BrandALLEN & HEATH
ModelOlive S3000
CategoryDJ Equipment
LanguageEnglish

Summary

Limited One Year Manufacturers Warranty

Conditions Of Warranty

Details the conditions under which the warranty is valid, including misuse, alteration, and authorized repair.

IMPORTANT - Read before starting

Safety instructions

Emphasizes reading safety instructions for user and performer safety, following all warnings.

1. Introduction

1.1 dLive Surfaces

Describes the three sizes of dLive Surfaces, highlighting shared I/O and differences in faders/touchscreens.

2. Rear Panel

MicLine inputs

Details the 8 recallable preamps for microphone and line level signals, including gain, pad, and 48V control.

Power Supply

Describes the hot-swappable power supply, its connections, and the option for a second PSU for redundancy.

gigaACE link

Explains the MixRack to Surface link over Gigabit Ethernet for audio and control, supporting redundancy.

3. Front Panel

Fader Strips

Provide control of channels, FX returns, masters, DCAs, monitors, or MIDI, with user-assignable layout.

Harmony UI - processing screen

Dedicated screen for channel processing, integrating touchscreen with wrap-around controls.

Harmony UI - system screen

System screen for status, setup, memory management, and mixer configuration.

4. Connect and power up

4.1 MixRack connection

Connects dLive Surface to MixRack using CAT5e cable via gigaACE ports, recommending two for redundancy.

4.3 Expander connection

Connects DX Expander to Surface DX port using CAT5e cable, recommending two for redundancy.

4.4 Connect a laptop or wireless router

Details connecting to network ports for dLive Editor/iOS apps and IP address configuration.

Related product manuals