1–14 Control Logic Wiring and Adapters
Publication 1336 IMPACT-6.2 – March 1998
All setup and operation information used by the drive is stored in a
system parameter table. Every parameter, including Setup and
Configuration parameters (Sources and Destinations), has an entry in
the parameter table. For example, parameter 29 is named the Speed
Ref 1 parameter and contains a number value representing the speed
reference. The speed reference can originate from an external control
device such as a potentiometer connected to the analog input of the
Main Control Board. Refer to the 1336 IMPACT User Manual,
Publication 1336 IMPACT-5.0.
AB Spares
To Next Page
Loading...
