Need help?Do you have a question about the Allen-Bradley 1305 Series and is the answer not in the manual?
General| Series | 1305 |
|---|---|
| Dimensions | Varies by model |
| Weight | Varies by model |
| Frequency Range | 50-60 Hz |
| Control Method | Volts per Hertz |
| Communication Interface | RS-485 |
| Enclosure Type | IP20 |
| Storage Temperature | -40-70°C |
| Humidity | 5 to 95% non-condensing |
Details input and output power connections via the ten position terminal block (TB1).
Covers recommended practices for running signal wiring and potential damage from external voltage.
Provides a step-by-step guide for users with a HIM to start up the drive.
Details initial checks and procedures before connecting the motor.
Explains how to select the drive's control scheme (e.g., 3-wire, 2-wire).
Provides steps to ensure the motor rotates in the correct direction after startup.
Group of parameters defining basic drive operation, programmed before initial operation.
Parameters providing information and settings for commonly viewed drive faults.
Displays fault messages on the LCD and corresponding fault numbers.
Provides methods to clear a fault, emphasizing corrective action first.
Lists detailed electrical, environmental, control, and feature specifications for the drive.
Details grounding requirements for safety and compliance with electrical regulations.
To Next Page