Allen-Bradley 1336 IMPACT - Page 45

2–10 Troubleshooting and Error Codes
Publication 1336 IMPACT-6.2 – March 1998
Fault Code and
Text
Suggested ActionDescription
Fault
Type
LED Information
06073
SP 1 Timeout
VP, Flashing green Warning
The SCANport adapter at port 1 has been
disconnected and the logic mask bit for
port 1 is set (1).
If the adapter was not intentionally
disconnected:
• Check the wiring to the SCANport adapters.
• Replace wiring, SCANport expander,
SCANport adapters, and main control board.
• Replace drive, if required.
If you do not want this condition to be
reported as a warning, change bit 9 in
Warning Select 1 (parameter 21) to 0.
06074
SP 2 Timeout
VP, Flashing green Warning
The SCANport adapter at port 2 has been
disconnected and the logic mask bit for
port 2 is set (1).
If the adapter was not intentionally
disconnected:
• Check the wiring to the SCANport adapters.
• Replace wiring, SCANport expander,
SCANport adapters, and main control board.
• Replace drive, if required.
If you do not want this condition to be
reported as a warning, change bit 10 in
Warning Select 1 (parameter 21) to 0.
06075
SP 3 Timeout
VP, Flashing green Warning
The SCANport adapter at port 3 has been
disconnected and the logic mask bit for
port 3 is set (1).
If the adapter was not intentionally
disconnected:
• Check the wiring to the SCANport adapters.
• Replace wiring, SCANport expander,
SCANport adapters, and main control board.
• Replace drive, if required.
If you do not want this condition to be
reported as a warning, change bit 11 in
Warning Select 1 (parameter 21) to 0.
06076
SP 4 Timeout
VP, Flashing green Warning
The SCANport adapter at port 4 has been
disconnected and the logic mask bit for
port 4 is set (1).
If the adapter was not intentionally
disconnected:
• Check the wiring to the SCANport adapters.
• Replace wiring, SCANport expander,
SCANport adapters, and main control board.
• Replace drive, if required.
If you do not want this condition to be
reported as a warning, change bit 12 in
Warning Select 1 (parameter 21) to 0.
06077
SP 5 Timeout
VP, Flashing green Warning
The SCANport adapter at port 5 has been
disconnected and the logic mask bit for
port 5 is set (1).
If the adapter was not intentionally
disconnected:
• Check the wiring to the SCANport adapters.
• Replace wiring, SCANport expander,
SCANport adapters, and main control board.
• Replace drive, if required.
If you do not want this condition to be
reported as a warning, change bit 13 in
Warning Select 1 (parameter 21) to 0.
06078
SP 6 Timeout
VP, Flashing green Warning
The SCANport adapter at port 6 has been
disconnected and the logic mask bit for
port 6 is set (1).
If the adapter was not intentionally
disconnected:
• Check the wiring to the SCANport adapters.
• Replace wiring, SCANport expander,
SCANport adapters, and main control board.
• Replace drive, if required.
If you do not want this condition to be
reported as a warning, change bit 14 in
Warning Select 1 (parameter 21) to 0.
AB Spares