8 POINT I/O 24V DC Expansion Power Supply
Publication 1734-IN058C-EN-P - October 2015
Install the Power Supply
To install the expansion power supply on the DIN rail, proceed as follows.
1. Position the power supply vertically above the DIN rail.
2. Engage the interlocking side pieces with the unit on the left.
3. Press down firmly to install the power supply on the DIN rail.
The locking mechanism locks the module to the DIN rail.
Remove the Power Supply
To remove an expansion power supply, proceed as follows.
1. Pull up on the RTB removal handle to remove the terminal block.
2. Remove the module to the right of the 1734-EP24DC module from its base unit.
3. Use a small-bladed screwdriver to rotate the DIN rail locking screw to a vertical
position.
This releases the locking mechanism.
4. Lift straight up to remove.
Replace the Power Supply
To install a replacement expansion power supply, proceed as follows.
1. Remove the module to the right of the power supply from its base unit.
2. Position the power supply vertically above the DIN rail.
To Next Page
Loading...
