Micro850 48 Point Programmable Controllers 7
Publication 2080-IN008C-EN-P - August 2017
Additional Resources
If you would like a manual, you can:
• download a free electronic version from the Internet:
http://rockwellautomation.com/literature
• purchase a printed manual by contacting your local Allen-Bradley distributor or
Rockwell Automation representative
ATTENTION:
• Electrostatic discharge can damage semiconductor devices inside the
module. Do not touch the connector pins or other sensitive areas.
• Do not remove the protective debris strips until after the controller and all
other equipment in the panel near the module are mounted and wired.
Remove strips before operating the controller. Failure to remove strips
before operating can cause overheating.
• Be careful when stripping wires. Wire fragments that fall into the controller
could cause damage. Once wiring is complete, make sure the controller is
free of all metal fragments.
Resource Description
Micro830
®
and Micro850
®
Programmable
Controllers User Manual, publication
2080-UM002
A more detailed description of how to install and use your
Micro830 and Micro850 programmable controller.
Micro800
™
AC Power Supply Installation
Instructions, publication 2080-IN001
Information on wiring and installing the optional AC power supply.
Micro800 Plug-in Modules User Manual,
publication 2080-UM004
Installation, wiring descriptions, and specifications for the
Micro800 plug-in modules.
Micro850 Expansion I/O Modules User
Manual, publication 2080-UM003
nstallation, wiring descriptions, and specifications for the
Micro850 expansion I/O modules.
Industrial Automation Wiring and
Grounding Guidelines, publication 1770-4.1
More information on proper wiring and grounding techniques.
To Next Page
Loading...
Need help?
General
