Equipment Phase Instructions
460 Rockwell Automation Publication 1756-RM006K-EN-P - November 2018
Equipment Phase Command on page 427
This instruction applies to the CompactLogix 5370 and CompactLogix 5380,
ControlLogix 5570 and ControlLogix 5580, and Compact GuardLogix 5370 and
Compact GuardLogix 5380 controllers.
Use the PSC instruction to signal an equipment phase that the state routine is
complete to indicate that it should go to the next state.
The PSC instruction signals the completion of a phase state routine.
In the running state routine, use the PSC instruction to transition the equipment
phase to the complete state.
Available Languages
Ladder Diagram
Function Block
This instruction is not available in function block.
Structured Text
PSC( );
Operands
Ladder Diagram
None
Phase State Complete (PSC)
To Next Page
Loading...
Need help?
General
