Allen-Bradley 5069-L340ER - User Manual

Installation Instructions
Original Instructions
CompactLogix 5380 Controllers
Catalog Numbers 5069-L306ER, 5069-L306ERM, 5069-L310ER, 5069-L310ER-NSE, 5069-L310ERM, 5069-L320ER, 5069-L320ERM, 5069-L330ER,
5069-L330ERM, 5069-L340ER, 5069-L340ERM, 5069-L350ERM, 5069-L380ERM, 5069-L3100ERM
The CompactLogix™ 5380 controllers can operate in various applications, including the use of local Compact 5000™ I/O modules and remote I/O
modules and Integrated Motion over an EtherNet/IP network. The controllers offer the following:
• High-speed backplane packet transfer rate
• Embedded dual 1 Gb Ethernet ports
• Multiple programming languages that enable sequential, process, motion, and drive control
You use the Studio 5000 Logix Designer® application to configure CompactLogix 5380 controllers.
For more information on the components that are required to install a CompactLogix 5380 controller, see
page 5. For more information on how to
use the controller after you install it, see the publications that are listed in
Additional Resources on page 15.
Summary of Changes
The publication has been changed as follows:
• Add Waste Electrical and Electronic Equipment (WEEE) information on
page 3.
• Add information about how to install an end cap on
page 11.
Topic Page
About the Controller 5
Required System Components 5
Install the Controller onto the DIN Rail 8
Connect External Power Supplies to the Controller 8
Install Compact 5000 I/O Modules 11
Install the End Cap 11
Power the System 12
Set the Network Internet Protocol (IP) Addresses 12
Connect the Controller to an EtherNet/IP Network 12
Remove or Replace the Controller 13
Specifications 14
Additional Resources 15

Allen-Bradley 5069-L340ER Specifications

General

Ethernet Ports	2
Power Supply	24V DC
Communication Ports	Ethernet/IP, USB
Product Type	Controller
Operating Temperature	0 to 60 °C
I/O Modules Supported	Compact 5000 I/O modules
Certifications	CE, UL, cUL

Summary

Safety and Environmental Information

Prevent Electrostatic Discharge

Guidelines to prevent damage from electrostatic discharge.

Controller Overview and System Preparation

Required System Components

List of essential components needed for controller installation.

System Power Considerations

Details on power requirements and supply sizing.

Installation Procedures

Install the Controller onto the DIN Rail

Step-by-step guide to mounting the controller onto a DIN rail.

Install the MOD Power RTB

Procedure for installing the Removable Terminal Block for MOD Power.

Connect External Power Supplies to the Controller

Steps for connecting external power supplies for MOD and SA power.

Install the SA Power RTB

Procedure for installing the Removable Terminal Block for SA Power.

Connect SA Power

Instructions for connecting DC or AC power supplies to the SA power RTB.

Install Compact 5000 I;O Modules

Install the End Cap

Network and System Operation

Power the System

Set the Network Internet Protocol (IP) Addresses

Connect the Controller to an EtherNet;IP Network

Remove or Replace the Controller