Allen-Bradley 5094-AENTR - User Manual

Installation Instructions
Original Instructions
FLEX 5000 EtherNet/IP Adapters with RJ45 Ports
Catalog Numbers 5094-AENTR, 5094-AENTRXT, 5094-AEN2TR, 5094-AEN2TRXT
Product Overview
The FLEX 5000™ EtherNet/IP Adapters with RJ45 Ports perform the following functions:
• Facilitate high-speed data transfer across an EtherNet/IP network between FLEX 5000 I/O modules and a Logix 5000™ controller.
• Provide system-side power to FLEX 5000 I/O modules.
• The 5094-AENTR and 5094-AENTRXT adapters support as many as 8 FLEX 5000 I/O modules.
• The 5094-AEN2TR and 5094-AEN2TRXT adapters support as many as 16 FLEX 5000 I/O modules.
The adapters are configured with the Studio 5000 Logix Designer® application. For more information on how to use FLEX 5000 EtherNet/IP
Adapters with RJ45 Ports, including the compatible Logix 5000 controllers and Logix Designer application versions, see the publications that are
listed in Additional Resources
on page 15.
Topic Page
About the Adapter 5
Before You Begin 5
Adapter Dimensions 6
Set the Network Internet Protocol (IP) Address 7
Install the Adapter onto the DIN Rail 8
Connect Power to the Adapter 9
Connect the Adapter to an EtherNet/IP Network 11
Install the End Cap 12
Power the Adapter 13
Remove or Replace the Adapter 13
Specifications 14
Additional Resources 15

Allen-Bradley 5094-AENTR Specifications

General

Model	5094-AENTR
Category	Adapter
Product Type	EtherNet/IP Adapter
Communication Protocol	Ethernet/IP
Number of Ports	2
Power Supply	24V DC
Network Address Translation (NAT)	No
Port Type	RJ45
Isolation	1500V
Certifications	CE
Status Indicators	Module Status, Network Status

Summary

Environment and Enclosure

North American Hazardous Location Approval

Approval for hazardous locations in North America.

European Hazardous Location Approval

Approval for hazardous locations in Europe (CE, EX II 3 G).

IEC Hazardous Location Approval

Approval for hazardous locations according to IECEx certification.

About the Adapter

Before You Begin

Lists components and tools needed for adapter installation.

Set the Network Internet Protocol (IP) Address

Install the Adapter onto the DIN Rail

Connect Power to the Adapter

Install the Power RTB

Instructions for installing the Power RTB on the adapter.

Connect Power to the Power RTB

Steps to connect external power to the Power RTB.

Connect the Adapter to an EtherNetIP Network

Install the End Cap

Install End Anchors onto the DIN Rail

Power the Adapter

Remove or Replace the Adapter

Specifications

Rockwell Automation Support

Technical Support Center

Access knowledgebase, FAQs, chat, and user forums.

Literature Library

Access installation instructions, manuals, and technical data.

Product Compatibility and Download Center (PCDC)

Determine product compatibility and download firmware.