Installation Instructions
Original Instructions
Compact 5000 I/O EtherNet/IP Adapters
Catalog Numbers
5069-AENTR, 5069-AENTRK, 5069-AEN2TR
The Compact 5000™ I/O EtherNet/IP adapters perform the following functions:
• Facilitate high-speed data transfer across an EtherNet/IP network between Compact 5000 I/O modules and a Logix 5000™ controller.
• Provide system-side and field-side power to Compact 5000 I/O modules.
• Support as many as 31 Compact 5000 I/O modules
The adapters are configured with the Studio 5000 Logix Designer® application. For more information on how to use Compact 5000 I/O
EtherNet/IP adapters, including the compatible Logix 5000 controllers and Logix Designer application versions, see the publications that are listed
in Additional Resources
on page 20.
Summary of Changes
The publication has been changed as follows:
• Add Waste Electrical and Electronic Equipment (WEEE) information on page 3
.
• Add information about how to install an end cap on page 17.
• Update the SA power and SA power Passthrough specification for the 5069-AENTR, and 5069-AENTRK adapters on page 19
.
Topic Page
About the Adapters 5
Install a Compact 5000 I/O System 6
Set the Network Internet Protocol (IP) Address 9
Install the Adapter onto the DIN Rail 10
Connect Power to the 5069-AEN2TR Adapter 10
Connect Power to the 5069-AENTR or 5069-AENTRK Adapter 13
Connect the Adapter to an EtherNet/IP Network 17
Install the End Cap 17
Power the System 18
Remove or Replace the Adapter 18
Specifications 19
Additional Resources 20
To Next Page
Need help?
General
