Publication 700-UM002A-EN-D - July 2001
3-6 Functions
Settings for Advanced Functions
ss hs
ss hs
Remaining
time
Elapsed
time
1 ms20 ms
s
s
0.01 s to 99,99 s (default setting)
0.1 s to 999.9 s
1 s to 9,999 s
0 min 01 s to 99 min 59 s
0.1 min to 999.9 min
1 min to 9,999 min
0 h 01 min to 99 h 59 min
Display
0.1 h to 999.9 h
Set Value
1 h to 9,999 h
0.001 s to 9.999 s
Set the key protect level using the keys.
Set the input signal width using the keys.
Set the twin timer output mode using the keys.
Key protect
level
Input signal
width
ON/OFF
start mode
Timer mode
Set the timer mode using the keys.
Set the ON time range using the keys.
For details, refer to
Time Range List
, below.
For details, refer to
Time Range List
, below
OFF time
range
ON time
range
Set the OFF time range using the keys.
(See note 2.)
(See note 1.)
3s min.
3s min.
Power ON
Run mode
Function setting
Note: 1. If the mode is switched to the function setting mode during operation, operation will
continue.
2. Changes made to settings in function setting mode are enabled for the first time when
the mode is changed to run mode. Also, when settings are changed, the timer is reset
(time initialized and output turned OFF).
Time Range List
For details on operations in run mode, refer to page
(Repeat
Cycle OFF start)
(Repeat
Cycle ON start)
3-4.
To Next Page
Loading...