86 Publication 2711C-UM001I-EN-P - July 2014
Chapter 6 Troubleshoot the System
Recipe 1021 Recipe /*S:0 Param1*/ failed. Cause: Unable to
read from /*S:0 Param2*/
Check the communication settings, and data point
specification.
Recipe 1022 Recipe /*S:0 Param1*/ failed. Cause: Unable to
read from Tag.
Check the communication settings, and data point
specification.
Recipe 1023 Recipe download failed. Cause: The value /*S:0
Param1*/ is greater than the maximum value
/*S:0 Param2*/ allowed for ingredient /*S:0
Param3*/
Correct the dataset value.
Recipe 1024 Recipe /*S:0 Param1*/ failed. Cause: Table does
not contain a recipe.
Restore the recipe in the table before doing a save
operation.
Recipe 1025 Recipe /*S:0 Param1*/ of recipe /*S:0
Param2*/failed. Cause: · Recipe file not
accessible.
Try to reload the application to see if the recipe is
still there, or restore from a .cha file from your
computer or SD card.
Recipe 1026 Recipe Upload Failed. This message is for informational purposes. No
corrective action needed.
Recipe 1027 Recipe operation in progress. This message is for informational purposes. No
corrective action needed.
Alert 2000 Loading. This message is for informational purposes. No
corrective action needed.
Alert 2001 Unloading. This message is for informational purposes. No
corrective action needed.
Alert 2002 Terminal is starting up... This message is for informational purposes. No
corrective action needed.
Alert 2003 Application is currently being edited, user input is
disabled.
Put the application into Test or Run mode to enable
user input.
Alert 2004 Copying file... This message is for informational purposes. No
corrective action needed.
Alert 2005 Deleting file... This message is for informational purposes. No
corrective action needed.
Alert 2006 Operation failed. This message is for informational purposes. No
corrective action needed.
Alert 2007 Operation succeeded. This message is for informational purposes. No
corrective action needed.
Alert 2008 Cannot run application. Application version
incompatible.
Edit, validate, and then save the application with
this version and try again.
Alert 2009 Cannot run application. Communication
connection not supported.
Terminal does not support the communication
connection configured in this application. Edit the
application and configure communication for the
supported connection type.
Alert 2010 This application is not validated. Are you sure you
want to run a non-validated application?
If you do not want to run the invalid application,
cancel the operation, then edit and validate the
application. Correct all validation errors, save the
application, and try again.
Alert 2011 Cannot run a modified application. Save the application and try again.
PanelView Component Terminal Alerts
Category ID Description Corrective Action
To Next Page
Loading...
Need help?
General
