Publication 2711C-UM001I-EN-P - July 2014 87
Troubleshoot the System Chapter 6
Alert 2012 Application has been modified. Continue without
saving?
Edit the application and save prior to performing this
operation, otherwise changes to the application may
be lost.
Alert 2013 Currently loaded application has been modified.
All changes will be lost by running this
application. Continue?
Edit the application and save prior to performing this
operation, otherwise changes to the application may
be lost.
Alert 2014 Application was designed for a different terminal
type and may not appear or operate as intended.
Continue?
Edit the application on the terminal type that it is
intended for.
Alert 2015 Application will be unloaded and deleted.
Continue?
Click Yes to continue with operation.
Alert 2016 Confirm deletion? Click Yes to delete the file.
Alert 2017 Confirm restart? Press Yes to restart the terminal.
Alert 2018 File already exists. Overwrite? If you do not want to overwrite the file, cancel the
operation and rename the file before performing this
operation.
Alert 2019 Cannot copy over loaded application. Unload
application and continue with overwrite?
Click OK to unload and overwrite the application.
Alert 2020 Cannot copy over loaded application. Unload application and try again.
Alert 2021 Insufficient space to complete file copy. Remove files to free space from the destination and
try again.
Alert 2022 Source and destination cannot be the same. Verify the source and destination are not the same
and retry.
Alert 2023 Application has been left in edit or test mode. Reconnect the designer or press OK to proceed to
the configuration screens.
Alert 2024 File not found.
Recipe 2025 Copy failed. Only existing recipe files can be
updated.
Create the recipe through the designer or rename
this recipe to the existing recipe name and try again.
Recipe 2026 Copy failed. Invalid recipe file. The imported recipe must have the same number of
ingredients and data sets as the existing recipe it is
replacing.
Alarm 2027 Alarm logs can only be copied from a loaded
application.
Load the application into Edit, Test, or Run mode and
retry.
Alert 2028 Files can only be copied to a secured application
while editing the application.
The application has been secured with design
rights. Load the application into Edit mode and retry.
Alert 2029 Files can only be copied from a secured
application while editing the application.
The application has been secured with design
rights. Load the application into Edit mode and retry.
Alert 2030 Cannot delete a loaded application. Unload application and try again.
Alert 2031 Files can only be deleted from a secured
application while editing the application.
The application has been secured with design
rights. Load the application into Edit mode and retry.
Alert 2032 Return to out of box condition? Press Yes to reboot the terminal and return to the
out of box condition.
Alert 2033 Source file does not exist. Make sure the source file exists and retry.
PanelView Component Terminal Alerts
Category ID Description Corrective Action
To Next Page
Loading...
Need help?
General
