Allen-Bradley PowerFlex 750 Series Installation Instructions

Installation Instructions
Original Instructions
PowerFlex 750-Series Service Cart and DC Precharge Module Lift
Catalog Numbers 20-750-MCART1, 20-750-MCART2, SK-RM-CARTCLIP, SK-RM-MPIN1, SK-RM- MBRIDGE1, 20-750-MPLT755T
Summary of Changes
This publication contains new and updated information as indicated in the following table.
Illustration Conventions
The following visual conventions are used in the IP00 kit installation illustrations:
Topic Page
Removed part numbers for spare parts 2
Updated section Conduct a Safety Check before Closing the Cabinet 28
Convention Description Convention Description Convention Description
Step number. Force application direction Electrostatic Discharge
(ESD) sensitive parts and
assemblies are identified in
this section by this image.
Take static control
precautions when you
install as assembly
identified as ESD sensitive.
Number of times the step is
performed.
Part/assembly placement
Topic Page
Summary of Changes 1
Before You Begin 2
Setup the Service Cart 4
Adjust the Service Cart 7
Remove the Power Module 8
Use the DCPC Module Lift (Optional) 13
Remove the DC Precharge Module (Optional) 14
Move the Power Module and the DC Precharge Module 16
Unload, Load, and Store the Power Module 19
Return the Power Module and the DC Precharge Module into the
Cabinet
22
Storage, Maintenance, and Customer Support 29
Additional Resources 30
1
=

Allen-Bradley PowerFlex 750 Series Specifications

General

Category	Controller
Series	PowerFlex 750 Series
Dimensions	Varies by model
Weight	Varies by model
Output Voltage Range	0V to Input Voltage
Output Frequency Range	0 to 400 Hz
Control Method	Vector Control
Communication Protocols	EtherNet/IP, DeviceNet, ControlNet
Enclosure Types	NEMA 1, NEMA 12, NEMA 4X, IP20
Safety	Safe Torque Off (STO)
Ambient Operating Temperature	0 to 40 °C (32 to 104 °F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Relative Humidity	5% to 95% (non-condensing)
Altitude	Up to 1000m (3280 ft) without derating