Need help?Do you have a question about the Allen-Bradley PowerFlex 750 Series and is the answer not in the manual?
General| Category | Controller |
|---|---|
| Series | PowerFlex 750 Series |
| Dimensions | Varies by model |
| Weight | Varies by model |
| Output Voltage Range | 0V to Input Voltage |
| Output Frequency Range | 0 to 400 Hz |
| Control Method | Vector Control |
| Communication Protocols | EtherNet/IP, DeviceNet, ControlNet |
| Enclosure Types | NEMA 1, NEMA 12, NEMA 4X, IP20 |
| Safety | Safe Torque Off (STO) |
| Ambient Operating Temperature | 0 to 40 °C (32 to 104 °F) |
| Storage Temperature | -40°C to 70°C (-40°F to 158°F) |
| Relative Humidity | 5% to 95% (non-condensing) |
| Altitude | Up to 1000m (3280 ft) without derating |
Summarizes warnings, cautions, and important notes for safe operation and installation.
Explains the ATEX directive and its compliance requirements for the ATEX option module.
Specifies the essential requirements for motors used in ATEX hazardous environments.
Describes the overall ATEX system architecture including motor and drive integration.
Details the safety function of the ATEX option module for over-temperature protection.
Emphasizes conducting a risk assessment of the installation environment before setup.
Highlights the importance of a safety analysis for the motor in ATEX applications.
General requirements for installing the ATEX option module assembly into the drive.
Detailed steps for installing the complete ATEX option module assembly into the drive.
Details ATEX motors with thermostatic switches and their functional testing.
Details ATEX motors with PTC devices and their functional testing.
Method for performing functional testing of the ATEX safety function without a test fixture.
Details the functionality and bit meanings of the ATEX Status parameter (Parameter 41).
Lists common ATEX-specific faults, their descriptions, and corrective actions.
Lists potential ATEX configuration conflicts and their resolutions.
To Next Page
