Allen-Bradley Stratix 5100 - Displaying Spanning-Tree Status

318 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 9 Configuring Spanning Tree Protocol
Displaying Spanning-tree
Status
To display the spanning-tree status, use one or more of the privileged EXEC
commands in this table.
For information about other keywords for the show spanning-tree privileged
EXEC command, see publication Cisco IOS Command Reference for Cisco
Aironet Access Points and Bridges.
Table 91 - Commands for Displaying Spanning-tree Status
Command Description
show spanning-tree Information on your network’s spanning tree.
show spanning-tree blocked-ports List of blocked ports on this bridge.
show spanning-tree bridge Status and configuration of this bridge.
show spanning-tree active Spanning-tree information on only active interfaces.
show spanning-tree root Summary of information on the spanning-tree root.
show spanning-tree interface interface-id Spanning-tree information for the specified interface.
show spanning-tree summary [totals] Summary of port states or the total lines of the STP state section appear.