186 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 5 Configure the Stratix 5100 WAP Using the Command-Line Interface
Example 2: Static WEP
This example shows part of the configuration that results from using the Security
page to create an SSID called
static_wep_ssid, excluding the SSID from the
beacon, assigning the SSID to VLAN 20, choosing 3 as the key slot, and entering
a 128 bit key:
ssid static_wep_ssid
vlan 20
authentication open
!
interface Dot11Radio0/1
no ip address
no ip route-cache
!
encryption vlan 20 key 3 size 128bit 7
FFD518A21653687A4251AEE1230C transmit-key
encryption vlan 20 mode wep mandatory
!
speed basic-1.0 basic-2.0 basic-5.5 basic-11.0
rts threshold 2312
station-role root
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
ssid statuc_wep_ssid
!
interface Dot11Radio0/1.20
encapsulation dot1Q 20
no ip route-cache
bridge-group 20
bridge-group 20 subscriber-loop-control
bridge-group 20 block-unknown-source
no bridge-group 20 source-learning
no bridge-group 20 unicast-flooding
To Next Page
Loading...