Why is no water coming out of my Allen + Roth 58101-X607011 Plumbing Product shower?
If there's no water coming out of your Allen + Roth Plumbing Product shower, first ensure the supply pipe is turned on so water reaches the slide bar. Then, check that the diverter at the bottom of the slide bar is also turned on to allow water to flow to the shower spray.
What to do if my Allen + Roth 58101-X607011 showerhead is leaking?
If the Allen + Roth Plumbing Product fix showerhead is leaking from the ball joint, it could be due to a missing washer. Replace the washer and tighten the ball joint. If you don't have a new washer, you can use sealant tape to assemble and seal the showerhead instead. Also, ensure the ball joint is properly tightened. If the hose connector leaks, the washer inside may be missing. Replace the washer, referring to steps 6&7 in the instructions, and tighten the connector, being careful not to overtighten.
How to fix a leak between the shower arm and slide bar on my Allen + Roth 58101-X607011?
If your Allen + Roth Plumbing Product slide bar is leaking at the joint with the shower arm, it might be due to a missing washer inside the connection nut. Replace the washer and tighten the nut securely. If the washer is present, simply tighten the connection nut.
Why won't the suction cup on my Allen + Roth 58101-X607011 stay on the wall?
If the suction cup and adhesive pad of your Allen + Roth Plumbing Product aren't staying firmly on the wall, it may be because the wall surface is too rough. It's recommended to install the slide bar with screws, following the instructions in steps 2.1, 2.1a, 2.1b, and 2.2. Also, ensure the suction cup is pressed tightly, as detailed in step 4 of the instructions.
General| Brand | Allen + Roth |
|---|---|
| Model | 58101-X607011 |
| Category | Plumbing Product |
| Language | English |
To Next Page