To Next PageTo Next PageWhat to do if Allen + Roth Bathroom Fixtures showerhead has reduced water flow?
If your Allen + Roth Bathroom Fixtures showerhead has reduced water flow, it might be due to debris clogging the showerhead connection. To resolve this, remove the showerhead and clear any debris that you find. If the problem persists after cleaning, contact customer service for a new showerhead and replace it after you receive it.
How to increase water flow in Allen + Roth Bathroom Fixtures tub spout?
If the tub spout on your Allen + Roth Bathroom Fixtures has no or reduced water flow, it could be that the angle stops or stop valves are not fully open. To fix this, completely open the angle stops and stop valves by rotating them counterclockwise with a flathead screwdriver (not included) until they can't rotate any further. This position indicates that the valves are fully open.
How to fix a leak from the handle of Allen + Roth Bathroom Fixtures?
If you notice a leak from under the handle or from the spout when your Allen + Roth Bathroom Fixture faucet is off, the bonnet nut might not be tight enough. Try removing the handle and retightening the bonnet nut. If the issue continues after tightening the nut, the cartridge may be damaged. In this case, contact customer service for a replacement cartridge, and replace the old one with the new one once you receive it.
Why is my Allen + Roth Bathroom Fixtures showerhead leaking at the connection?
If you're experiencing a leak from the connection between the showerhead and shower arm of your Allen + Roth Bathroom Fixtures, it may be due to thread sealant tape being used. Remove the showerhead, take off any thread sealant tape, and then reattach the showerhead directly to the shower arm. The seal washer inside the showerhead is designed to create a seal. If the seal washer is missing, contact customer service for a replacement showerhead and replace it after you receive the new showerhead.
General| Brand | Allen + Roth |
|---|---|
| Model | 873X-5B04 |
| Category | Bathroom Fixtures |
| Language | English |
Time needed for assembly.
Tools needed for installation.
Tools that are useful but not essential.
Prepare the installation area, verify hole sizes and positions.
Remove screws (J) and plaster guard (I).
Connect hot/cold supply lines and tub outlet pipes.
Adjust cartridge for reversed supply connections.
Flush water lines to remove debris and check for leaks.
Place and secure plaster guard onto the valve body.
Insert shower arm into flange and wall connection.
Thread tub spout onto the connection until flush with the wall.
Remove plastic cap from valve body before installing escutcheon.
Attach handle, turn on water, check for leaks, then remove handle.
Attach escutcheon, handle, and showerhead.
Unscrew and remove handle assembly and escutcheon from the valve body.
Note and remove the stop ring from the cartridge assembly.
Adjust stop ring clockwise for colder, counterclockwise for hotter water.
Replace escutcheon and handle assembly onto the valve body.
Addresses leaks from handle or spout when off.
Troubleshoots issues with tub spout water flow.
Addresses leaks at the showerhead/arm connection.
Diagnoses and fixes low water flow from the showerhead.
