What to do if Allen + Roth 873X-7104 showerhead has reduced water flow?
If your Allen + Roth Bathroom Fixtures showerhead has reduced water flow, it might be due to debris clogging the showerhead connection. To resolve this, remove the showerhead and clear any debris that you find. If the problem persists after cleaning, contact customer service for a new showerhead and replace it after you receive it.
How to fix a leak from the handle of Allen + Roth 873X-7104 Bathroom Fixtures?
If you notice a leak from under the handle or from the spout when your Allen + Roth Bathroom Fixture faucet is off, the bonnet nut might not be tight enough. Try removing the handle and retightening the bonnet nut. If the issue continues after tightening the nut, the cartridge may be damaged. In this case, contact customer service for a replacement cartridge, and replace the old one with the new one once you receive it.
Why is my Allen + Roth 873X-7104 Bathroom Fixtures showerhead leaking at the connection?
If you're experiencing a leak from the connection between the showerhead and shower arm of your Allen + Roth Bathroom Fixtures, it may be due to thread sealant tape being used. Remove the showerhead, take off any thread sealant tape, and then reattach the showerhead directly to the shower arm. The seal washer inside the showerhead is designed to create a seal. If the seal washer is missing, contact customer service for a replacement showerhead and replace it after you receive the new showerhead.
How to increase water flow in Allen + Roth 873X-7104 Bathroom Fixtures tub spout?
If the tub spout on your Allen + Roth Bathroom Fixtures has no or reduced water flow, it could be that the angle stops or stop valves are not fully open. To fix this, completely open the angle stops and stop valves by rotating them counterclockwise with a flathead screwdriver (not included) until they can't rotate any further. This position indicates that the valves are fully open.
Ensure correct hole sizes and valve depth for installation.
Install valve body, connect supply lines, and secure plaster guard.
Configure valve orientation, flush system, and check for leaks.
Attach shower arm, tub spout, and prepare for escutcheon.
Install escutcheon, handle, showerhead, and perform final leak checks.
Detach handle/escutcheon, identify stop ring position on cartridge.
Modify stop ring for desired hot water temperature limit.
List of available replacement parts with their corresponding part numbers.
General| Lighting Technology | Incandescent |
|---|---|
| ADA Compliant | No |
| WaterSense Certified | No |
| Light Bulb Base Type | Medium (E26) |
| Material | Metal |
| Installation Type | Wall Mount |
To Next Page