Operation
Getting Started
Before using the reader, it is necessary to first fully
charge the battery pack as described in battery
management section.
Switch on / off instructions
Press and release the “SCAN” button once to turn the
reader on. At start-up, it will switch on the RED light and
beep once.
Note 1 - Once activated, the reader will stay on
for 2 minutes by default and then shut down
automatically emitting two beeps.
Reading a transponder
To search for tags, press and release the SCAN button.
When searching for tags, the red light will flash. The
reader will continue searching tags for 3 seconds until a
tag is found or the time is elapsed.
To Next Page
Loading...
