The reader emits a single beep when the Bluetooth
connects and 3 beeps when it disconnects.
Note 2 – When the reader is connected in slave
mode, the reader stays on for 1 hour.
Note 3 – When the reader is configured in Master
mode, you can force it to Slave mode by
keeping pressed the button for 15 seconds at
start-up. During these 15 seconds, the reader will
progressively warn that the return to slave mode
is ongoing (blinking blue led, audible warning)
The default passkey of the built-in Bluetooth
®
is 1234.
To pair your smartphone to your LPR reader, go into
Bluetooth settings of your smartphone and turn on
Bluetooth if currently disabled.
To Next Page
Loading...
