Need help?Do you have a question about the Alliance Laundry Systems ATG50FGP111TW01 and is the answer not in the manual?
General| Brand | Alliance Laundry Systems |
|---|---|
| Model | ATG50FGP111TW01 |
| Category | Washer/Dryer |
| Type | Top Load Washer |
| Capacity | 3.2 cu. ft. |
| Color | White |
| Voltage | 120V |
| Frequency | 60 Hz |
| Water Level Selections | Multiple |
| Amperage | 15 A |
| Cycle Options | Delicate |
Instructions for finding a qualified service technician for the appliance.
Contact information for obtaining literature, replacement parts, or technical assistance.
Guidance on where to find the product's model and serial numbers.
Lists applicable model numbers for the information in this manual.
Explains the operational components and functions of the stacked unit.
Details resistance values for testing the washer's motor and tachometer circuit.
Addresses a knocking noise in the frontload washer caused by a belt issue.
Diagnoses and resolves "no spin" issues related to the out-of-balance switch wiring.
Service procedures for dryers where the timer does not advance in automatic cycles.
Troubleshooting flowchart for a dryer where the motor fails to operate.
Dryer stops mid-cycle, has burning smell, or cycles on motor thermal protector.
Guide for diagnosing why the dryer motor runs but the cylinder remains stationary.
Troubleshooting steps for a dryer where the motor fails to shut off.
Diagnoses issues where the dryer operates only when the door is open.
Procedures for when the dryer's heating system fails to activate or ignite.
Troubleshooting steps when the igniter on a gas dryer does not glow.
Addresses gas dryer burners that ignite and then shut off repeatedly.
Troubleshooting for gas dryers where the igniter glows but the burner fails to ignite.
Steps to diagnose why the dryer's heater or burner cycles off too soon.
Explains troubleshooting for repeated cycling off due to the limit thermostat.
Diagnoses issues where the dryer's heater assembly or burner fails to turn off.
Troubleshooting guide for clothes not drying properly in the dryer.
Procedures for when the dryer's timer fails to advance during automatic cycles.
Troubleshooting steps for clothes being excessively hot after drying.
Addresses chattering or vibrating noises originating from the dryer.
Troubleshooting guide for humming or whistling noises in the dryer.
Lists and explains various error conditions and their corresponding LED indicators.
Troubleshooting steps for a washer that shows no power or response to the start switch.
Diagnoses "door open" errors where wash/rinse LEDs flash.
Troubleshooting for a washer that does not engage the door lock, indicated by a flashing door LED.
Steps to diagnose why the washer motor does not run, with specific LED indications.
Addresses "no fill" errors and communication issues indicated by flashing LEDs.
Troubleshooting guide for a washer that is experiencing overflows.
Steps to diagnose why the washer's drain pump is not functioning.
Troubleshooting for serial communication errors indicated by flashing LEDs.
Instructions for adjusting the leveling legs to ensure the unit is stable.
Procedures for adjusting the washer's loading door for proper alignment.
Steps for adjusting the tension of the washer's motor drive belt.
Instructions for repairing or adjusting the washer's door catch mechanism.
Information regarding factory-installed shipping supports for the washer/dryer.
Guide for adjusting the burner flame on gas dryer models.
Procedures for testing the electrical contacts within the dryer timer.
Testing procedures for the dryer's fabric selector switch.
Instructions for testing the dryer's drive motor resistance.
Step-by-step guide for testing and replacing the dryer motor switch.
Explanation of the gas burner system's operation and circuits.
Testing the electrical circuit for the ignition system on gas dryers.
Procedures for checking the resistance of gas valve coils on gas dryers.
Steps for testing the sensor on gas dryer models.
Instructions for checking the igniter's resistance on gas dryer models.
Procedures for testing the thermal fuse on electric dryer models.
Testing the resistance of the heater assembly on electric dryer models.
Steps for testing the cycling or limit thermostat.
Testing procedures for the dryer's door switch.
To Next Page
