8 38934
Timer
Although the washer cycles are automatic, the timer may
be reset to lengthen, shorten or repeat a portion of a cycle.
Agitation and spin speeds are automatically set for you.
To set or reset the timer, push timer knob in to stop
the washer. Hold timer knob in firmly while turning
it clockwise to the setting desired. Pull timer knob out
to start the washer. Do not turn the knob
counterclockwise.
Automatic Cycles
Regular
Use for sturdy items, like play or work clothes, towels,
T-shirts, etc. The wash time selection will depend on the
type of fabric and the amount of soil. For the best results
when cleaning heavily soiled items, use a longer wash
time (15 minutes maximum). Lightly soiled items require
less wash time.
There are three settings in the REGULAR cycle —
Normal, Medium, and Light. The number shown next to
these settings is the length of agitation in minutes. (For
example: Setting the timer on Normal will be a 15 minute
agitation).
Permanent Press Cycle
Use for permanent press items and synthetics. The wash
time selection will depend upon the type of fabric and
amount of soil.
There are two settings in the PERMANENT PRESS
cycle — Normal and Light. The number shown next to
these settings is the length of agitation in minutes. (For
example: Setting the timer on Normal will be a nine
minute agitation).
Delicate
Wash delicate items usually washed by hand on this
cycle. A full tub of water is recommended (even for small
loads) to allow the delicate items to move freely through
the water. More water helps reduce fabric wear,
wrinkling, and provides for a clean wash.
There are two settings in the DELICATE cycle —
Normal and Light. The number shown next to these
settings is the length of time in minutes. (For example:
Setting the timer on Normal will be nine minutes
including short periods of agitation and long periods of
soaking.)
Soaking
Set the timer knob in the center of the word “RINSE” or
the washer may spin without first filling with water. Place
the soaking product and clothes load in the washtub. Pull
timer knob out to start water fill. After fill is completed
and agitation has started, push the timer knob in. This will
stop the washer. When the clothes have soaked the
desired length of time, TURN THE TIMER KNOB TO
THE END OF THE RINSE SETTING, then pull the
timer knob out to start the spin.
CAUTION: Failure to turn the timer knob to the
spin cycle and completely draining the washtub
after soaking will result in the washer overflowing
and causing property damage.
W529I
To Next Page
Loading...
