Safety Information
7
D1590ENR2
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Safety Decals
Important Information Before
Installation
Transportation and Storage
IMPORTANT: In case of transportation and
storage, watch components protruding from the
contour line of machine (door locks, etc.) to avoid
injuries.
• Never push, pull or exert pressure on components
protruding from the machine contour line
(controls, door locks, etc.).
• Make sure that these components are secured so
as to avoid damages during machine
manipulation and installation.
• In case of machine transportation by the
customer, follow the manufacturer’s instructions
for transportation, handling and storage of the
product. In case of transportation of the machine
by customer, the manufacturer is not responsible
for possible damage to the machine in the course
of transportation. In case of storing the machine
in a free area, it must be protected against
mechanical damage and weather conditions.
For Installation
IMPORTANT: All connections must be performed
by qualified personnel with a proper authorization
according to this manual in compliance with local
standards
• The washer must not be installed or stored in an
area where it will be exposed to water and/or
weather. Avoid damp conditions where water or
moisture could run down the walls and covers of
the washer or cover the floor around the washer.
Do not install the washer above an open gutter.
Close any nearby gutters so that the waste water
steam cannot collect near/inside the washer.
• Any changes in the machine installation must be
approved by the dealer or manufacturer.
Otherwise, the dealer or manufacturer is not
responsible for possible injuries or damages.
Interference and changes in the machine
construction are not allowed and the
manufacturer refuses an responsibilities in such
cases.
• Define dangerous areas in the laundry room and
do not allow people to enter if the machine is in
operation.
Machine Information
• This manual comprises information for the soft-
mount machine series 75/335, 90/400, 125/520,
180/800, 230/1000 and 275/1200. Verify the
machine model according to your order and the
data plate located on the machine rear and find
corresponding information in the manual.
• The machines are controlled by electronic
controller. Find the programming instructions in
the Programming Manual.
• Additional heating can be provided by electrical
heating elements or by steam from an external
steam supply.
• Water inlets can use warm, cold, soft and cold
hard water. A machine can be equipped with
recycled discharging, dosing pumps for liquid
soaps and/or a tilting system.
• Electrical setup of the machine is indicated on the
data plate (Figure 2, pos. 11).
Do not remove warning signs placed on
the appliance. Observe signs and labels to
avoid personal injuries. Safety labels
appear at crucial locations on the
appliance. Failure to maintain legible
safety labels could result in injury to the
operator or service technician.
W833
WARNING
Original or identical parts must be used for
replacement in this machine. After
servicing, replace and secure all panels in
the original way. Take these measures for
continued protection against electrical
shock, injury, fire and/or property damage.
W837
WARNING
To Next Page
Loading...
