To Next PageTo Next Page
Need help?Do you have a question about the Alliance Laundry Systems UWN045T4V and is the answer not in the manual?
General| Brand | Alliance Laundry Systems |
|---|---|
| Model | UWN045T4V |
| Category | Washer |
| Language | English |
Explains the meaning of DANGER, WARNING, CAUTION, IMPORTANT, and NOTE.
Lists basic precautions to reduce risk of fire, electric shock, injury, or death.
Details safety precautions for machine operators.
Describes the importance of maintaining legible safety decals.
Lists the models to which this manual is applicable.
Instructions for visually inspecting the unit for shipping damage upon delivery.
Contact info for parts, literature, and technical assistance.
Details on machine dimensions, clearances, and mounting points.
Details on cylinder dimensions, volume, perforation, and door opening size.
Data on cylinder speeds, centrifugal forces, and electrical/steam heating options.
Diagram and explanation of mounting bolt hole locations for different machine configurations.
Table providing dimensional clearances for various points of the machine.
Diagrams showing standard side-by-side and back-to-back floor layouts.
Requirements for single machine, existing floor, new, and isolated pad foundations.
Details on constructing concrete pads and foundation requirements.
Specifies minimum foundation thickness, excavation depth, and pad sizes.
Procedures for mounting and grouting the machine to the foundation.
Figures and details for installing L-speed and 45 lb M-speed models.
Figures and details for installing 65 lb M-speed models.
Figures and details for installing V-speed models.
Procedures and diagrams for using cast-in-place and acrylic adhesive anchors for mounting.
Table detailing static and dynamic load specifications for the machine.
Instructions and diagrams for direct drain and drain trough systems.
Table for sizing drain lines based on the number of machines.
Safety warnings and requirements for connecting water supply lines.
Important warnings and guidelines for electrical connections and safety.
Wiring diagrams for machines with and without electric heat.
Table detailing electrical specs for 45 lb capacity models across different speeds and heat options.
Table detailing electrical specs for 65 lb capacity models across different speeds and heat options.
Electrical specifications for CE marked 45 lb capacity models.
Electrical specifications for CE marked 65 lb capacity models.
Information on steam supply pressure, connection size, and number of inlets.
Details on the chemical supply connection, ports, and safety precautions.
Recommended method for wiring chemical injection using the machine's internal transformer.
Instructions for wiring chemical injection using an external AC power source.
Explanation of wash-cycle signals provided to external chemical supply equipment.
Step-by-step guide for operating machines with the UniLinc control system.
Description of the Shakeout agitation step and its purpose.
Step-by-step guide for operating machines with the M30 control system.
Instructions on how to select wash cycles using numeric keypads and reference Table 14.
Procedures for initial machine start-up, including basket rotation and safety switch checks.
Procedures for daily checks and cleaning, including door interlock and hoses.
Tasks to perform at the end of the day, such as cleaning the AC drive filter and door gasket.
Procedures for weekly checks, including leak checks and drain valve verification.
Procedures for monthly maintenance, including bearing lubrication and V-belt checks.
Procedures for quarterly maintenance, including tightening fasteners and checking painted surfaces.
Guidelines for cleaning and maintaining stainless steel surfaces to prevent damage and corrosion.
